Ace Factory Price Hardware Balustrade Cable Stainless Steel Railing for Decks

DIY Cable Railing / Wire Rope Railing Balustrade with Stainless Steel Wire Ropes for decking

1. What can we do for you ?

1:Bespoke Design; 
    
2:Punctual Delivery; 

3:China Manufactured 

4:Price Match Guarantee

2:How to Measure up your Balustrade?

1:Get out your sketchpad and draw a bird's eye view of the area where you want the balustrade to be placed;
2:You can either draw all corner and end posts onto your sketch. Or alternatively measure the outside edge of the area.
3:Now that your end and corner posts are drawn or your outside measurements taken, insert the distances on your drawing. 
4:With your measurements to hand you can now  send in your drawings to us.

3:What are you fixing your system to ?

When deciding on whether to buy and install a balustrade system it is essential that the system is fited to a solid fixture ground. This includes ood such as composite decking, metal, brick or concrete. If this is not the case we cannot be held liable for the system being structurally unsound.  

The type of ground or wall your fitting o will affect what fixtures you require. Find bew typical examples;

Wood:                                   Coach screws or Coach Bolts

METAL                                 Screws, Nuts & Bolts, Drill & Tap steel or Bolt straight through.
BRICK/ CONCRETE             Anchor bolts, Thunder bolts or Threaded bar and resin.

These fixings ae purely a guide and are not suitable for every application. 

PLEASE NOTE:  
DO NOT ARRANGE FOR INSTALLERS UNTIL ALL YOUR ITEMS HAVE ARRIVED AND BEEN THOROUGHLY CHECKED.

4:How to install your  balustrade?

Below are typical examples of fixing methods. These my not be suitable for your installation

WOOD                               drill 6mm pilot hole 80mm, use M8 x 100mm stainless steel coach screws.
METAL                               drill and tap M8, use M8 x 50 stainless steel bolts with locking washers
BRICK/CONCRETE           drill 8mm holes to depth of 80mm, use M8 x 100mm stainless steel floor                                                                   anchor fixing

1:Once you have positioned your post and inserted your fixings, tighen them hand tight Now check your post for 2:plumb and level. Hold the spirit level where the glass would run as well as at the front and back of the posts. 3:Shim as necessary till the post is level. Once done please repeat this with all other posts. 

5:How do we pack ?

 Well wrapped up in EPE foam in a Carton, and then put it in Sealed  plywood crates